Panels must be stored flat on a clean, dry surface. Pre-condition for at least 24 hours at temperature and moisture level typical for the area after construction.

Leave 1/8" between and 3/16" at the top and bottom of each panel.

Moldings provide a finished look to an installation. When moldings are used in conjunction with a quality caulk/sealant, a moisture resistant wall surfacing can be achieved. CAUTION: exposed OSB substrate will absorb moisture. Failure to use moldings and sealant may allow swelling, deterioration of substrate and weaken the laminate bond.

DURO-LAM panels should be installed with adhesive and mechanical fasteners. Use a quality cartridge style construction adhesive.

Always follow all adhesive, sealant and fastener manufacturer's instructions. Make sure that walls or studding to be covered are structurally sound, level and true. Plan so that panel edges meet on studding. Cut and pre-fit panels allowing for expansion and contraction. If moldings and caulking are utilized, insure that caulking is applied to moldings as they are installed.

Install rivets starting from the center of panel. Work outwards, securing the perimeter last. Arrange fasteners on 16" centers with outer fasteners placed about 1" from panel edges. Stagger rivet rows 8" to